DYNOJET DYNOJET QUICK SHIFTER (DQS) USB/V SENSORS ROD-D MALE/FEM M6/8

Races of a Second Dynojet's Quick Shifter (DQS) Kit Allows Full-Throttle, Clutchless Upshifts In Racing and Performance Riding Applications Shift Rod Pressure/Tension Sensors Push or Pull Configuration; Requires Modification of Gear-Linkage Tie Rod Linear Travel Sensor Kit Works With Bikes That Have No Shift Rod, Or On Those The Shift Rod Sensor Will Not Fit, By Mounting One End To The Shift Lever and The Other To A Fixed Point On The Chassis ; Available in Push or Pull Types with Universal Mounting Hardware Plugs Directly into the Power Commander Expansion Port With No Rewiring Required Power Commander Commander Control Center Software Lets You Set Engine Dead Time During Upshifts and Minimum RPM for System Operation Part# 1601-0510 And 1601-0512 "Pressure Style" Sensors for PCV/USB and Have Two Terminals, So It Can Eithher Act As "Push" Or "Pull" Type Part #s 1601-0013 and 1601-0014 Are "Linear" Sensors for PCIII USB Part #s 1601 -0246 and 1601-0247 are "linear" sensors for pcv dynojet quick shifter (dqs) Sensors USB/V Note: To Order Eithher of the Above Sensors, You Must Find the Correct Direction of Movement During An Upshift (Push or Pull). For the Shift Rod/Pressure/Sensor Tension, Press On The Shift Lever in the Direction of An Upshift to see if the Rod is Pushing or Pulling on The Clevis On The Shift Shaft. For the Linear Travel Sensor, Also Move The Shifter for An Upshift. If movement is download, a pulle is needed sensor. If movement is up, A Push sensor is required. Shift Rod Type Shift Rod-D Male/Fem M6/8