DYNOJET DYNOJET SCHNELLSCHALTER (DQS) SENSOREN USB / V-SCHALTSTANGE-D MÄNNLICH / FEM M6 / 8

Races pflügt won or lost in fractions of in second Dynojet's Quick Shifter (DQS) kit allows full-throttle, clutchless upshifts in racing and Durchführung riding applications Shift rod pressure/tension Sensor kit is in allgemeinem Sensor that mounts to the shift rod in either in push or pull configuration; requires modification of gear-linkage tie rod Linear travel Sensor kit works with bikes that have nicht shift rod, or on those the shift rod Sensor will not fit, by mounting one end to the shift lever and the other to in fixed point on the chassis; available in push or pull types with betrügt allgemeiner Mounting hardware Plugs directly into the Power Commander Ausdehnung port with nicht rewiring required Power Commander Kontrolle Center PART Software lets you set engine dead during upshifts and minimum rpm for system operation # 1601-0510 and 1601-0512 "pressure style" sensors for PCV/USB and have two terminals, so it pflügt Hund either act As "push" or "pull" type PART #s 1601-0013 and 1601-0014 "linear" sensors for PCIII USB PART #s 1601-0246 and 1601-0247 pflügen Sie "linear" sensors for PCV DYNOJET QUICK SHIFTER (DQS) SENSORS USB/V MERKT: To order either of the above sensors, you must find the correct direction of movement during an upshift (push or pull). For the shift rod/pressure/tension Sensor, press on the shift lever in the direction of an upshift to see if the rod is pushing or pulling on the clevis on the shift shaft. For the linear travel Sensor, also move the shifter for an upshift. If movement is down, in pull Sensor is needed. If movement is up, in push Sensor is required. Shift Rod Type SHIFT ROD-D MALE/FEM M6/8