DAYTONA TWIN TEC LLC TWIN SCAN DIAGNOSTIC KITS FOR HARLEY-DAVIDSON Twin Scan 3 Probe kit For Twin Scan 3 ABS Communicates with ECM, TSSM and BCM to read, then clear diagnostic trouble codes
Activate ABS solenoids for proper brake bleeding and testing
Real time display of engine sensors along with built in data logging will store data for up to one hour
Les données de journalisation automatique des données sont disponibles sur un code d'accès complet et un code de date et d'after est défini
PART #3807-0445 programmes et reads key fobs, programs PIN and disable security
Activate modules, lights, indicators fuel pump drain and electronic throttle sweep ; tests different actuators, lights and indicators
Calibrate speedometer, remove new speedometer display of VinErr
Enables ou disables settings in the ECM such as ACR (automatic compression release for performing engine compression testing), EITMS, cruise control, and active épuist, reads and sets engine idle speed rpm
Enables ou disables settings in the BCM for ignition switch, new radio installation, bank angle détecteur for trike installs, program fog light function, ABS installation, and enable service state
Latest logiciel will include the latest firmware for easy remote updating of the Twin Scan 4
Includes two analog inputs with 0-20V ou ± 200V range as well as two-channel oscilloscope capability for waveform display
Analog inputs can also be used for air / flow ratio (AFR)
Easy to navigate software
Requires use of a PC with Windows 7, Windows 8 or Windows 10 for display
WEGO IIID double channel wide-band épuisé gaz automgen détecteur interface upgrade kit PART #1022-0224 will log engine data along with the current air / fuel ratio (AFR) ; logged AFR data can be analyzed and displayed.
Utilisez le kit PART #3807-0189 to use scopemeter function ; includes two insulation-piercing probes and 12V power adapters
Utilisez PART #1022-0008 for replacement Bosch O2 capteur (sold each)
Made in the U.S.A.
TWIN SCAN DIAGNOSTIC KITS
NOTE: Models equipped with 12mm oxygen sensors will require 18mm weld nuts be installed in the épuist system for use with the Twin Scan 3 + kit 18mm oxygen sensors.